Getting started

You’ll need a USB audio interface and your own .nam captures (TONE3000 is a good source). Connect your interface, tap START, then tap an empty slot to load a capture.

Adding more captures to one amp

Select the slot, then tap the folder icon at the top left. Multiple captures stack in the same slot — flip between them with the ‹ › arrows under PRESET.

Removing a capture

Tap the trash icon next to PRESET. You can remove a single capture or clear the whole slot.

Amp artwork

Long-press a slot to assign a photo. The background is removed automatically.

Visualizer

Double-tap the display to cycle color modes. The expand icon opens full-screen performance mode.

No sound?

Make sure you’re monitoring through your interface rather than the iPad speaker, and that a capture is loaded and BYPASS is off.

Contact [email protected] — I read every message